Zanussi-Electrolux ZRD 1843 Manuel d'utilisateur télécharger pdf (Page 17)

Door Reversal

Disconnect the appliance from the electricity

supply.

Tilt back the appliance carefully. It is recommended

to ask another person for help, who can keep the

appliance at this position safely.

Unscrew on the both sides adjustable feet (2

pieces) and the fixing screws (2 pieces) of bottom

door holder and the far side screws (2 pieces) too.

Take off the door of the refrigerator by pulling it

slightly downwards.

Dismount the double door holder by removing the

screws (2 pieces).

Take off the door of the freezer by pulling it slightly

downwards.

Unscrew the top door holding pin of the freezer,

then screw it back on the other side.

Remove the covering nails of the double door

holder on the left side and put them to the other

side.

Fit the door of the freezer to the top door holding

pin.

Fix the double door holder onto the left side using

the screws (2 pieces). Be careful that the door

edge of the freezer is parallel with the edge of the

mantle.

Fit the door of the refrigerator to the double door

holding pin.

Fix the bottom door holder onto the left side using

the screws (2 pieces) and the adjustable foot as

well as screw the 2 pieces screws on the opposite

side into the vacant holes. Be careful that the door

edge of the refrigerator is parallel with the edge of

the mantle.

Put over the handle on the opposite side and cover

up the vacant holes with the plastic nails from the

bag of instruction book.

After released the screws the adaptation of the

doors can be adjusted with the horizontal control of

central door holder.

Put the appliance to its place, set it level and

connect to the electricity supply.

In case you do not want to perform the procedures

above, call the nearest brand-mark service.

Technicians will accomplish the refitting expertly for

charge.

Important

After completion of the door reversing operation,

check that the door gasket adheres to the cabinet. If

the ambient temperature is cold (i.e. in Winter), the

gasket may not fit perfectly to the cabinet. In that case,

wait for the natural fitting of the gasket or accelerate

this process by heating the part involved with a normal

hairdryer on a low setting.

1 2 ... 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Zanussi-Electrolux ZRD 1843 Manuel d'utilisateur Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Congélateurs Zanussi-Electrolux ZRD 1843