Zanussi-Electrolux ZWF1451W Manuel d'utilisateur télécharger pdf (Page 28)

Unpacking

The transport safeguard must be removed before

putting the appliance into operation.

Important !

You are advised to keep all the packaging for re-use in

case the machine is to be transported again.

●

After removing all the packaging, with assistance

carefully lay machine on it’s back to remove the

polystyrene base from the bottom.

●

Remove the power supply cable and the draining hose

from the hose holders on the rear of the appliance.

●

With a suitable spanner unscrew and remove the

central rear bolt A. Slide out the relevant plastic

spacer.

●

Unscrew and remove the two large rear bolts B and

the six smaller bolts C.

●

Remove the bracket D and tighten up the six smaller

bolts C.

●

Open the porthole and remove the polystyrene block

fitted with the adhesive tape on the door seal.

HEC0010

HEC0011

HEC0003

HEC0002

HEC0001

HEC0008

●

Fill the smaller upper hole and the two large ones with

the corresponding plastic plug caps supplied in the

bag containing the instruction booklet.

Important!

All the different plug caps are supplied with the

appliance in the plastic bag containing the instruction

booklet.

●

Connect the water inlet hose as described under the

paragraph “Water inlet”.

Positioning

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is not

impeded by carpets, rugs etc. Check that the machine does

not touch the wall or other kitchen units.

Never place cardboard, wood or similar materials under the

machine to compensate for any unevenness in the floor.

Your new washing machine has been designed to be

permanently plumbed in to your home’s water supply

and drainage system. However, if this is not possible, it

may be connected to suitable existing tap with the drain

hose discharging into a sink.

The appliance has one inlet hose, with female 3/4” BSP

thread connector. If this connection is not compatible

with the plumbing of the existing installation, a variety

of connectors are available from good hardware stores

and plumbers merchants to suit most domestic

plumbing. Any alteration to your existing plumbing

must be carried out by a competent person, or qualified

plumber.

Installation on a Suspended Floor

Suspended wooden floors are particularly susceptible to

vibration. To help prevent vibration we recommend you

place a waterproof wood panel, at least 15 mm thick

under the appliance, secured to at least 2 floor beams

with screws. If possible install the appliance in one of

the corners of the room, where the floor is more stable.

HEC0009

HEC0005

1 2 ... 23 24 25 26 27 28 29 30 31 32

Commentaires sur ces manuels

Pas de commentaire

Zanussi-Electrolux ZWF1451W Manuel d'utilisateur Page 28

Commentaires sur ces manuels

Produits connexes et manuels pour Machines à laver Zanussi-Electrolux ZWF1451W